Cluster accounts

Access restriction

Euler is available to everyone at ETH Zürich, as well as gests and collaborators.
Leonhard med is only available to its shareholders. Guests cannot access it.

Account Creation

On your first login, you need to accept the cluster's usage rules:

Please note that the Euler cluster is subject to the "Acceptable Use Policy
for Telematics Resources" ("Benutzungsordnung fuer Telematik", BOT) of ETH
Zurich and relevant documents (https://tinyurl.com/eth-bot), in particular:
 
 * your Euler account (like your ETH account) is *strictly personal*
 * you are responsible for all activities done under your account
 * you must keep your password secure and may not give it to a 3rd party
 * you may not share your account with anyone, including your supervisor
 * you may not use someone else's account, with or without their consent
 * you must comply with all civil and criminal laws (copyright, privacy,
   data protection, etc.)
 * any violation of these rules and policies may lead to administrative
   and/or legal measures
 
Before you can proceed you must confirm that you have read, understood,
and agree to the rules and policies mentioned above.

Afterwards a verification code is sent to your ETH email address (your-username@ethz.ch).

An access code has been sent to your registered email address.
Enter the access code at the prompt below.
If you have not received the access code within a few minutes,
then contact us by opening a ticket at
http://smartdesk.ethz.ch

Access code (ending on ******qV):

If entered correctly, a new account will automatically be created.

Troubleshooting

No verification code

Please check the spam folder in your mailbox. Maybe the mail has been filtered by your spam filter

Requesting an account for the Euler cluster does not work

A request for an Euler account is only required if you use the cluster for the first time. Please check if you already have access. If this is not the case, please contact cluster support.

No prompt to enter the verification code

Certain settings in your SSH config can cause an issue, where you don't get any prompt to enter the verification code after entering your password. Please try again to login to the cluster using the following additional SSH options:

-o PreferredAuthentications=keyboard-interactive -o PubkeyAuthentication=no